ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 95
L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING INTERFACE
Shows the user the physical and logical port associated with each DLCI. This is a read-only field.
L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING > DLCI
This DLCI (Data Link Connection Identifier) number identifies the virtual circuit being configured.
L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING > MODE
The mode identifies how the data will be forwarded. The choices are:
L2 PROTOCOL (TDM–T1–FRE) > CONFIG > DLCI MAPPING > BECN TIMEOUT (MSEC)
This value is expressed in milliseconds and represents the amount of time the unit will stop transmitting
over a PVC which received a packet with the BECN bit set. Range is
50-5000 msec; the default is
50
MILLLISECONDS
.
L2 PROTOCOL (TDM–T1–FRE) > STATUS
View the L2 protocol status for the T1 interface using the Frame Relay protocol.
L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT
View the Frame Relay statistics on the WAN port.
L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > PORT INDEX
Integer used for identifying DLCIs on an interface. A single DLCI will always be port index 0. Subsequent
DLCIs will have incrementing port indices.
L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > SIGNAL STATE
Displays “up” when the unit is communicating with the Frame Relay switch; otherwise displays “down”.
L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > TX FRAMES
Total frames transmitted out the WAN port.
L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > RX FRAMES
Total frames received from the WAN port.
L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > TX BYTES
Total bytes transmitted out the WAN port.
L2 PROTOCOL (TDM–T1–FRE) > STATUS > PORT > RX BYTES
Total bytes received on the WAN port.
R
OUTE
IP (def) All IP data for this DLCI will be routed.
B
RIDGE
A
LL
All data for this DLCI will be bridged.
R
OUTE
UIP/B
RIDGE
OTHER
All IP data will be routed. All other data will be bridged.

   Find Your Products By Category