ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Section 4 User Interface Guide Total Access 600 Series System Manual
76 © 2004 ADTRAN, Inc. 61200624L1-1B
INTERFACES (SHDSL) > STATUS > G.HS EVENT
Internal ADTRAN use only.
INTERFACES (SHDSL) > STATUS > G.HS STATE
Internal ADTRAN use only.
INTERFACES (SHDSL) > STATUS > ANNEX
Displays the current G.shdsl signaling method as either A
NNEX
A or A
NNEX
B.
INTERFACES (SHDSL) > STATUS > EOC STATS
Displays statistics for information transferred between the Total Access 6XX and the DSLAM over the
EOC.
INTERFACES (SHDSL) > STATUS > PERFORMANCE
Displays the current layer one SHDSL information including signal to noise ratio (SNR), errored seconds
(ES), severely errored seconds (SES), unavailable seconds (UAS), and code violations.
I
NTERFACES
(N
ETWORK
SDSL)
View the network SDSL interface status and configure SDSL parameters from this menu. These menus are
only applicable to SDSL Total Access 600 Series systems.
INTERFACES (SDSL) > CONFIG
Configure the various SDSL parameters from this menu (such as DSLAM type).
INTERFACES (SDSL) > CONFIG > DSLAM
Specify the type of DSLAM the Total Access 6XX SDSL unit is connected to. Choices include: N
OKIA
D50
, L
UCENT
S
TINGER
, and C
OPPER
M
OUNTAIN
CE150. DSLAM setup parameters will vary depending on
configured DSLAM type.
INTERFACES (SDSL) > CONFIG > DSLAM SETUP
Configure the DSLAM settings from this menu.
INTERFACES (SDSL) > CONFIG > DSLAM SETUP > TRAINING
Specifies the training method for the SDSL link as either F
IXED
R
ATE
(using only the specified rate) or
F
AST
EOC (which allows for the fastest negotiated rate).
INTERFACES (SDSL) > CONFIG > DSLAM SETUP > BIT RATE
Configures the fixed data rate used when training the SDSL link. This menu only applies when the
Training parameter is specified for
F
IXED
R
ATE
. Using a fixed data rate requires the DSLAM to be
configured for the same rate as the Total Access 6XX. Choices vary depending on configured DSLAM and
range from
144K to 2320K.

   Find Your Products By Category