ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Section 4 User Interface Guide Total Access 600 Series System Manual
118 © 2004 ADTRAN, Inc. 61200624L1-1B
BRIDGE > CONFIG > INTERFACES (NETWORK)
Configure the network interface bridging parameters from this menu.
BRIDGE > CONFIG > INTERFACES (NET) > SUB-INTERFACE
The network sub-interface is PPP [0.0] if the L2
PROTOCOL
is set for PPP. The [0.0] represents the network
physical and logical ports respectively. This is a read-only field. The network sub-interface is
FRE [0.X] if
the
L2
PROTOCOL
is set for
F
RAME
R
ELAY
. The [0.X] represents the network physical and logical ports
respectively. The network physical port is always 0. The X represents the Frame Relay logical port and
will be a number between 0-6 corresponding to the interface number under
L2 PROTOCOL > CONFIG >
DLCI MAPPING
. This is a read-only field.
BRIDGE > CONFIG > INTERFACES (ETH)
Configure the Ethernet Bridging parameters from this menu.
BRIDGE > CONFIG > INTERFACES (ETH) > SUB-INTERFACE
This is a read-only field which displays the physical and logical port of the interface using the following
nomenclature: [A.B], where A represents the physical port (network interface is 0, Ethernet is 1) and B
represents the logical port for the Layer 2 protocol (i.e. PVC for Frame Relay, PPP link, etc.) Each
configured logical port is assigned a number corresponding to the order in which they are listed in the L2
Protocol configuration fields.
BRIDGE > CONFIG > BRIDGE TABLE
Configure the bridge table parameters from this menu.
BRIDGE > CONFIG > BRIDGE TABLE > BRIDGE TABLE AGING (0-65535)
B
RIDGE
T
ABLE
A
GING
is how soon an entry ages out of the Bridge table (in minutes). Default is 5.
BRIDGE > STATUS
View the bridging statistics from this menu.
BRIDGE > STATUS > BRIDGE TABLE
View the bridge table status from this menu.
BRIDGE > STATUS > BRIDGE TABLE > MAC ADDRESS
Ethernet address for device learned. This is a read-only field.
The ETH interface will not appear as a bridge interface entry if the mode is set to route IP.

   Find Your Products By Category