ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 87
INTERFACES (FXO) > CONFIG
Configure the FXO mode, line impedance, and Tandem parameters from this menu.
INTERFACES (FXO) > CONFIG > PORT
Indicates the port of the FXO module.
INTERFACES (FXO) > CONFIG > MODE
Choices are given below. Default is L
OOP
S
TART
.
INTERFACES (FXO) > CONFIG > TX (
d
B)
Sets the TX direction level points. This signal will change the volume of the voice. TX (dB) is the signal
that is transmitted out the T1, with 0 dB being the strongest. If the volume is too loud across the T1, this
number should be increased. A higher number indicates more attenuation which equals lower volume. The
value entered must be less than 10 dB. Default is
0.0 dB.
INTERFACES (FXO) > CONFIG > RX (
d
B)
Sets the RX direction level points. This signal will change the volume of the voice for the signal being
transmitted by the Total Access 6XX out the interface. A higher number indicates more attenuation which
equals lower volume. The value entered must be less than 10 dB. Default is
0.0 dB.
INTERFACES (FXO) > CONFIG > SVC MODE
Indicates whether the module is I
N
S
ERVICE
or O
UT
OF
S
VC
. This does not indicate whether the port has
been mapped.
INTERFACES (FXO) > STATUS
Displays the status of the FXO signal bits.
This mode must match the network configuration and/or how each port is being used. Each
port on the FXO Module is independent and should be set accordingly.
L
OOP
S
TART
Sets the port to use FXO loop start signaling on the T-span and loop
start supervision on the analog 2-wire interface.
G
ROUND
S
TART
Sets the port to use FXO ground start signaling on the T-span and
ground start supervision on the analog 2-wire interface.
DPT
Sets the port to use Dial Pulse signaling to terminate dialed numbers.
M
ODIFIED
DPT
Sets the port to use DPT signaling on the interface. In DPT mode, digits
are transmitted out the FXO interface to the user equipment. DPT mode
is one-way operation for outbound calls towards user equipment on the
2-wire side.

   Find Your Products By Category