ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Section 4 User Interface Guide Total Access 600 Series System Manual
58 © 2004 ADTRAN, Inc. 61200624L1-1B
SYSTEM CONFIG > SYSLOG > SYSLOG IP
IP address of the syslog daemon to which log message should be sent. The values must be dotted decimal
notation.
SYSTEM CONFIG > SYSLOG > SYSLOG FORMAT
The S
YSLOG
F
ORMAT
is the format of log messages. "A
DTRAN
" uses a format that is compatible with
ADTRAN Utilities and forces the Syslog Facility to LOCAL0.
U
NIX
uses the traditional Unix format and
reports at the configured facility level.
SYSTEM CONFIG > SYSLOG > SYSLOG FACILITY
The choices are: L
OCAL
0, L
OCAL
1, L
OCAL
2, L
OCAL
3, L
OCAL
4, L
OCAL
5, L
OCAL
6, L
OCAL
7. S
YSLOG
F
ACILITY
is the facility level for all messages forwarded from the unit to the syslog server. This allows all messages
received from the IAD to be filtered by facility level. See RFC3164: The BSD Syslog Protocol.
The remaining Syslog parameters have the following level choices:
FATAL (Highest priority)
ALERT
CRITICAL
ERROR
WA RNI NG
NOTICE
INFO
DEBUG (Lowest priority)
Every log message generated by the IAD has a reporting level priority. If the message priority is lower than
the configured priority for the destination log, the message is not forwarded to the syslog daemon. See
RFC3164: The BSD Syslog Protocol. The lower the log level, the more messages that will be generated.
Setting reporting levels to DEBUG may negatively affect the performance of the IAD, including causing
the IAD to reset.
ADTRAN Utilities may malfunction if messages are received in the Unix format.
This does not have to correspond to the facility level shown in the terminal mode option.
See
SYSLOG using Terminal Mode on page 59.
ADTRAN recommends using DEBUG for only short periods of time, and for debug
purposes only.

   Find Your Products By Category