ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Section 4 User Interface Guide Total Access 600 Series System Manual
92 © 2004 ADTRAN, Inc. 61200624L1-1B
L2 PROTOCOL (TDM–T1–PPP) > CONFIG > PPP > MAX TIMER (SEC)
This value is the numbers of seconds to wait between unanswered configuration-requests. The possible
values are
1
SEC
, 2
SECS
, 3
SECS
(def), 5
SECS
and 10
SECS
.
L2 PROTOCOL (TDM–T1–PPP) > CONFIG > PPP > MAX FAILURE
Due to the nature of PPP, configuration options may not be agreed upon between two PPP peers. This
value is the number of configuration-naks that should occur before an option is configuration-rejected. The
possible values are
5 (def), 10, 15, and 20.
L2 PROTOCOL (TDM–T1–PPP) > CONFIG > PPP > KEEPALIVE PERIOD
This option allow the user to generate PPP keepalive packets that can be sent one every 1 minute, 2
minutes or every 5 minutes. A value of 0 (def) disables the PPP keepalive packet generating feature.
L2 PROTOCOL (TDM–T1–PPP) > CONFIG > PPP > FORCE PEER IP ADDRESS
This option forces the PPP to negotiate the IP address entered instead of allowing the IP address to be
assigned by the remote end.
L2 PROTOCOL (TDM–T1–PPP) > CONFIG > PPP > SEND IDENTIFICATION
When enabled, this option enables the Total Access 600 Series to send the system identification code in
response to a configure acknowledgement from the peer equipment. For most peer routers this option
should be configured as
Y
ES
. If set to N
O
, the Total Access 600 Series will accommodate peer routers that
do not correctly respond to the identification code.
L2 PROTOCOL (TDM–T1–PPP) > STATUS
View the L2 P
ROTOCOL
status for the T1 interface using the PPP protocol.
L2 PROTOCOL (TDM–T1–PPP) > STATUS > LCP
Link Control Protocol. Reflects the LCP layer active.
L2 PROTOCOL (TDM–T1–PPP) > STATUS > BCP
Shows UP if PPP Bridge Control Protocol has negotiated successfully.
L2 PROTOCOL (TDM–T1–PPP) > STATUS > IPCP
Shows UP if PPP IP Control Protocol has negotiated successfully.
L2 PROTOCOL (TDM–T1–PPP) > STATUS > UP TIME
Displays how long the PPP session has been connected.
L2 PROTOCOL (TDM–T1–PPP) > STATUS > TX PKTS
Number of packets transmitted on the T1 interface.

   Find Your Products By Category