ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 85
INTERFACES (FXS) > CONFIG > TANDEM > DIAL TONE
Used to enable or disable the on-board dial tone generation. Dial Tone is supplied for 5 sec; then it drops. It
cannot be broken when dialing digits. Default is
D
ISABLE
.
INTERFACES (FXS) > CONFIG > TANDEM > RING BACK TONE
Used to enable or disable the option of generating ring back tone towards the T-span. Default is D
ISABLE
.
INTERFACES (FXS) > CONFIG > TANDEM ANSWER SUPERVISION
Causes the polarity of tip and ring to be reversed when the far-end answers. Can be E
NABLED
or D
ISABLED
.
Default is
D
ISABLE
.
INTERFACES (FXS) > CONFIG > TANDEM > DNIS OPTIONS
This parameter is used in conjunction with
DNIS D
ELAY
. Choices are
D
ISABLE
,
E
NABLE
, and
E
NABLE
W
/
NO
A
NSWER
W
INK
. Default is D
ISABLE
.
INTERFACES (FXS) > CONFIG > TANDEM > DNIS DELAY
Sets the amount of time the voice module waits after it receives a wink before forwarding a DNIS digit if
DNIS O
PTIONS
is set to E
NABLE
. Choices are 0.5
SEC
, 1.0
SEC
, 2.0
SEC
, 2.5
SEC
, 3.0
SEC
, and 5.0
SEC
.
Default is
3.0
SEC
.
INTERFACES (FXS) > CONFIG > TANDEM > FWD DISC DELAY
In Tandem mode, F
WD
D
ISC
D
ELAY
defines the time battery is actually removed/reversed once the forward
disconnect is received. Choices are
250
MSEC
, 500
MSEC
, 750
MSEC
, 1
SEC
, and 2
SEC
. Default is 1
SEC
.
INTERFACES (FXS) > CONFIG > TANDEM > FWD DISC BATTERY
In Tandem mode, selects whether battery is to be removed or reversed during forward disconnect. Choices
are
R
EMOVE
and R
EVERSE
. Default is R
EMOVE
.
INTERFACES (FXS) > STATUS
Displays the status of the FXS signal bits.
INTERFACES (FXS) > STATUS > PORT
Displays the port number.
INTERFACES (FXS) > STATUS > TA SIG
This parameter displays the status of the Transmit A signal bit. The high/low status is indicated by a 0 or 1.
INTERFACES (FXS) > STATUS > TB SIG
This parameter displays the status of the Transmit B signal bit. The high/low status is indicated by a 0 or 1.

   Find Your Products By Category