ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 161
3. Verifying the Bridge Options
For more details on the configuration parameters discussed in this section, refer to the following pages:
Bridge menus beginning on page 117
4. Mapping the DS0s
For more details on the configuration parameters discussed in this section, refer to the following pages:
DS0 Map menus beginning on page 149
3
Set mode to B
RIDGE
A
LL
. Using this menu you also have the option to route
only IP packets and bridge all other data packets (R
OUTE
IP/B
RIDGE
O
THER
) or
route all IP data packets on this connection (R
OUTE
IP). Refer to
L2 Protocol
(ALL–ETH–802.3) > Config > Mode on page 116
for more details.
4
Left arrow back to the main menu to save the changes.
Bridge Options
Step Action
1
From the main menu, select B
RIDGE
and press <E
NTER
>.
2
Use the right arrow key to highlight C
ONFIG
and press <E
NTER
>.
3
Select I
NTERFACES
and press <E
NTER
>. Verify that the desired interface is
listed in this table.
4
Left arrow back to the B
RIDGE
> C
ONFIG
menu.
5
Select B
RIDGE
T
ABLE
and set the B
RIDGE
T
ABLE
A
GING
to the desired time (in
minutes) it takes an entry to age out of the Bridge table.
6
Left arrow back to the main menu to save the changes.
DS0 Mapping Instructions
Step Action
1
From the main menu, select DS0 M
APS
.
Layer 2 Protocol Configuration – Ethernet Interface (Continued)

   Find Your Products By Category