ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 51
S
YSTEM
C
ONFIG
Set up the unit’s operational configuration from the S
YSTEM
C
ONFIG
menu. Figure 4 shows the items
included in this menu.
Figure 4. System Config Menu
SYSTEM CONFIG > MANAGEMENT
Set up the CRAFT port, T
ELNET
A
CCESS
, SNMP M
ANAGEMENT
, and FDL M
ANAGEMENT
from this menu.
SYSTEM CONFIG > MANAGEMENT > CRAFT PORT
Set up the CRAFT port parameters from this menu. The unit’s VT100 CRAFT port can be accessed via an
RJ-48 connector located on the rear of the unit.
SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > PASSWORD PROTECT
When P
ASSWORD
P
ROTECT
is set to N
O
, the CRAFT port is not password protected. When set to Y
ES
(def),
the unit will prompt for a password upon startup.
SYSTEM CONFIG > MANAGEMENT > CRAFT PORT > PASSWORD
Enter the user-defined password (up to 30 alphanumeric characters including spaces and special
characters) to protect the
CRAFT port. By default, no password is entered. Table 2 on page 52 provides
instructions for changing the password.
Connecting directly to the CRAFT
port provides full access to all menus. Enable the
password on the
CRAFT port to protect against unauthorized access.

   Find Your Products By Category