ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 105
L2 PROTOCOL (ATM–NET–ATM) > CONFIG > PVC CONFIG > SETUP (V35)
Use these menus to configure the V35 parameters for this logical connection from the T1 interface to the
V.35 port. These menus are only applicable when the
C
ONNECTION
parameter is set to V35.
M
AX
C
ONFIG
This value is the number of unanswered configuration-requests that should be
transmitted before resetting PPP negotiations. the possible values are
5, 10, 15,
and
20 (def).
M
AX
T
IMER
(
SEC
)
This value is the number of seconds to wait between unanswered
configuration-requests. The possible values are
1
SEC
,
2
SECS
,
3
SECS
(
DEF
)
,
5
SECS
, and 10
SECS
.
M
AX
F
AILURE
Due to the nature of PPP, configuration option may not be agreed upon between
two PPP peers. This value is the number of configuration-naks that should occur
before an option is configuration-rejected. The possible values are
5 (
DEF
), 10,
15, and 20.
F
ORCE
P
EER
IP A
DDRESS
This option forces the PPP to negotiate the IP address entered instead of
allowing another address to be assigned by the remote end. The default is
N
O
.
K
EEPALIVE
P
ERIOD
This option allows the user to generate PPP keepalive packets that can be sent
every
1 minute, 2 minutes, or every 5 minutes. A value of 0 (O
FF
) disables the
PPP keepalive packet generating feature. The default is
0 (O
FF
).
PPP E
NCAPSULATION
This option allows the user to set the encapsulation modes for PPP over ATM.
LLC has an encapsulation header in the AAL5 frame indicating it is
encapsulating PPP. VC-Mux does not have a header, and is therefor dedicated to
using PPP. The choices are
LLC or VC-M
UX
. The default is VC-M
UX
.
S
END
I
DENTIFICATION
When enabled, this option enables the Total Access 600 Series to send the
system identification code in response to a configure acknowledgement from the
peer equipment. For most peer routers this option should be configured as
Y
ES
.
If set to
N
O
, the Total Access 600 Series will accommodate peer routers that do
not correctly respond to the identification code.

   Find Your Products By Category