Honeywell Building Set Bluetooth Ring Scanner User Manual

0

Out of 0 Ratings

Owner's of the Honeywell Building Set Bluetooth Ring Scanner gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 244
 
3 - 1
3
Bluetooth Module Programming Bar Codes
Introduction
Bar codes in this section are designed to be read by a ring scanner or ring imager connected to the Bluetooth Ring Scanner
module.
This section contains programming bar codes to be used when programming the Bluetooth Ring Scanner module only. The bar
codes were created using Code 128 ASCII. An asterisk (*) next to an option indicates the default setting. Honeywell scanners
and imagers are setup to read Code 128 bar codes by default.
• The ring scanner, that is a part of the Bluetooth Ring Scanner product, has an SE955 scan engine. Use 1D Laser Scanner
Programming Bar Codes (page 4-1) to program the ring scanner engine parameters.
• The ring imager, that is a part of the Bluetooth Ring Scanner product, has an SE4400 scan engine. Use 2D Laser Imager
Programming Bar Codes (page 5-1) to program the ring imager scan engine parameters.
Preparation
Assemble the Bluetooth Ring Scanner components.
Connect a ring decoder to the Bluetooth Ring Scanner module before inserting a battery into the module. The Bluetooth Ring
Scanner module performs initialization with the Ring Scanner on bootup. A fully charged battery must be secured in the module
battery well.
A ring scanner or ring imager can be tethered to the Bluetooth Ring Scanner module. Either ring device can be used to read the
Bluetooth Ring Scanner module programming bar codes in this section.
When parameters are changed, and saved to memory, the Bluetooth Ring Scanner module LED blinks. Bar codes cannot be
scanned until the LED color returns to normal mode.
The scan engine manufacturer may offer more bar codes and options than are contained in this guide. Note that the bar codes
in this guide are only those supported by Honeywell and the imagers or scanners linked to mobile devices that Honeywell
manufactures or supports. Contact Customer Support (page 10-1) if you need help when using the bar codes in this guide.
Module Programming Bar Codes
To change a parameter value scan the appropriate bar code in this section. The new value replaces the default value in
memory. An asterisk (*) next to an option in this section indicates the default setting.
Note: Imager White LED programming bar codes have been replaced by the bar codes in Decoding Illumination (page 5-8) and
LED Illumination (page 5-10).
Bluetooth Ring Scanner Module Factory Default Settings
Pairing Status (page 3-3) Slave Mode Enabled
Suspend Timeout (page 3-4) 5 minutes
Beep on Reconnect (page 3-5) Enabled
Reconnect Timeout (page 3-7) 30 seconds
Reconnect Timeout (page 3-7) 1 minute
Role Switching (page 3-8) Enabled
Authentication (page 3-9) Disabled
Encryption (page 3-9) Disabled
PIN Code (page 3-12) 16 zeros
Friendly Name (page 3-13) “LXE Scanner” + Module MAC address
Ring Imager Focus Mode (page 3-11) Smart Focus
Beep Volume (page 3-10) High

   Find Your Products By Category