Honeywell Building Set Bluetooth Ring Scanner User Manual

0

Out of 0 Ratings

Owner's of the Honeywell Building Set Bluetooth Ring Scanner gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 244
 
2 - 7
4. Press down on the battery until it is seated in the battery bay and close the battery bay hatch cover. Slide the battery
latch to the left to secure the battery in the Bluetooth Module.
5. The Bluetooth module beeps (short low tone beep, long low tone beep, long high tone beep) and the module LED
flashes.
Module Battery Help
Issue:
There is no beep or LED flash when inserting battery into the module.
Solution:
If a ring scanner is tethered to the Bluetooth module while a battery is being replaced and there is no beep or LED flash,
remove the battery, turn it over and reinsert, making sure the battery terminals enter the battery bay to the right. Slide the
battery bay latch to the left to secure the battery in the Bluetooth Module. If there is sufficient power in the battery, the Blue-
tooth module emits a series of beeps (short low tone beep, long low tone beep, long high tone beep) and the LED flashes.
Adjusting the Ring Device Strap
The ring device finger loop is located under the ring device. The ring device has a built-in quick disconnect designed for safety
hazards. The quick disconnect is not intended for daily removal of the ring device.
1. Pull gently on the end of the finger loop strap to separate the hook and loop fabric.
1. Slide your finger into the opened loop under the ring device.
1. Grasp the end of the finger loop strap and gently pull to loosen then tighten the finger strap until the ring device is comfort-
ably snug and the scan aperture is in the desired location.
1. Secure the ring strap at the desired location by pressing the hook fabric to the loop fabric on the strap surrounding the finger.
Status LEDs and Beep Indicators
The ring devices do not have the ability to emit a good decode read sound (after a bar code scan) or bad decode read sound.
The Bluetooth Ring Scanner module emits the good read or bad read sounds. The module and the ring devices have an LED.
1. Module LED
2. Module Beeper
3. Ring Decoder LED

   Find Your Products By Category