Honeywell Building Set Bluetooth Ring Scanner User Manual

0

Out of 0 Ratings

Owner's of the Honeywell Building Set Bluetooth Ring Scanner gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 244
 
2 - 4
Wrist Strap / Back of Hand Strap
Ring Imager / Ring Scanner
The ring imager can scan and decode 1D and 2D bar codes. The imager has three small illumination LEDs at the top of the
scan window or aperture.
The ring scanner can scan and decode 1D bar codes. The scanner does not have illumination LEDs.
After pairing with a Bluetooth enabled mobile computer, the ring device can then send the collected bar code data through
the module to the Bluetooth enabled mobile computer for processing. The Bluetooth Ring Scanner module emits good
read or bad read sounds based on the ring scan results. See Status LEDs and Beep Indicators (page 2-7) for an explana-
tion of the LED and beep patterns emitted.
These ring decoding devices do not have the ability to emit a good read or bad read sound.
Do not touch, push against or brace your finger on the scan aperture at any time.
When new, there is a clear, tabbed protective film covering the ring decoder scan window. Remove and discard the clear,
tabbed protective film before scanning a bar code.
1. Loops
2. Elastic ring cable protector
3. Bluetooth module sleeve
4. Hooks
Ring Imager Ring Scanner Cable Connector

   Find Your Products By Category