Honeywell Building Set Bluetooth Ring Scanner User Manual

0

Out of 0 Ratings

Owner's of the Honeywell Building Set Bluetooth Ring Scanner gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 244
 
2 - 8
Scanning bad bar codes generates a bad scan beep and/or an LED light sequence. In some cases, the receipt of data from the
ring device triggers a good scan beep from the Bluetooth module, and then the rejection of scanned bar code data by the paired
mobile device processing causes a bad scan beep from the paired mobile device on the same data.
See the mobile device specific guide for an explanation of the LED and beep indicators for the paired device. For example, if
you have paired the Bluetooth Ring Scanner with the MX7 Tecton so the MX7 Tecton can manipulate the scanned bar code data
received from the Bluetooth Ring Scanner module, refer to the MX7 Tecton User's Guide for MX7 Tecton LED and beep
explanations.
Note: Bluetooth device connection (or pairing) can occur at distances up to 32.8 ft (10 meters) line of sight. Distances greater
than the line of sight limit will break the connection. Arriving at the limit may cause unexpected beep and/or LED
indications. When the connection is broken, the Bluetooth Ring Scanner Module attempts to reconnect with a previously
paired device for 30 seconds. Move the Bluetooth Ring Scanner Module closer to the target. A disconnected paired
device beeps on reconnect.
Bluetooth Module Status LED and Beep Indicators
The Bluetooth Module blue LED and buzzer indicate status as follows:
Blue LED System Condition Indication
Fast blink, 0.25 sec.
duration every 1.0 sec.
Radio Failure Short high tone beep
Short high tone beep
Short low tone beep
Short low tone beep
Fast blink, 0.25 sec.
duration every 1.0 sec.
Pairing Failed Short low tone beep
Short high tone beep
Short high tone beep
Short low tone beep
Slow blink, 0.25 sec.
duration every 4.0 sec.
Successful Connection Short low tone beep
Short high tone beep
[When Beep on Connect is enabled. See Bluetooth
Module Programming Bar Codes (page 3-1)]
Fast blink, 0.25 sec.
duration every 1.0 sec.
Lost Connection Short high tone beep
Short low tone beep
[When Beep on Connect is enabled. See Bluetooth
Module Programming Bar Codes (page 3-1)]
Slow blink, 0.25 sec.
duration every 4.0 sec.
Connected None
Fast blink, 0.25 seconds
every 1.0 second
Not Connected None
Off Suspend or Off (not tethered or
no battery power available in
Bluetooth Module)
None
Blue Bluetooth Module firmware is
updating
None
Off Bluetooth Module firmware
update is completed
Module restarts and power-up beep occurs
Fast Blink, 0.25 sec
duration every 0.5 sec.
Communication Error None
None Beep on <BEL> error Three Short low tone beeps
None Power Up Short low tone beep
Long low tone beep
Long high tone beep

   Find Your Products By Category