0

Out of 0 Ratings

Owner's of the Cisco Systems Home Security System Cisco Asa 5505 10-User Bundle gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 52
 
4-6
Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide
OL-18362-01
Chapter 4 Maintenance and Upgrade Procedures
Upgrading Memory
Replacing an SSC
To replace an existing SSC, perform the following steps:
Step 1 Enter the hw-mod mod 1 shut command in privileged EXEC mode. Verify if the module is down by
checking the LEDs.
Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare
skin. Attach the other end to the chassis.
Step 3 Remove the two screws (as shown in Figure 4-4) at the left rear end of the chassis.
Step 4 Remove the SSC. Set it aside.
Step 5 Replace the existing card by inserting the new SSC through the slot opening as shown in Figure 4-5.
Step 6 Attach the screws to secure the SSC to the chassis.
Step 7 Enter the hw-mod mod 1 reset command in privileged EXEC mode to reset the SSC.
Step 8 Check the LEDs. If the SSC is installed properly, the STATUS LED flashes green.
Step 9 Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices.
Upgrading Memory
The memory upgrade kit, ASA5505-MEM-512=, allows you to upgrade the Cisco ASA 5505 to 512 MB
of memory. To determine how much memory your adaptive security appliance has, use the show version
command:
hostname# show version
Cisco Adaptive Security Appliance Software Version 8.0(0)
Device Manager Version 6.0(0)
Compiled on Mon 16-April-07 03:29 by root
System image file is "disk0:/cdisk.bin"
Config file at boot was "disk0:/main_backup.cfg"
hostname up 2 days 10 hours
failover cluster up 2 days 11 hours
Hardware: ASA5505, 256 MB RAM, CPU Pentium 4 Celeron 2000 MHz
BIOS Flash M50FW016 @ 0xffe00000, 2048KB
Table 2 lists the memory for the Cisco ASA 5505.
Table 2 Memory Upgrade
Model Current Memory Upgrade to
Cisco ASA 5505 256 MB 512 MB