Garmin GPS Receiver Garmin 18X GPS Receiver Module User Manual

0

Out of 0 Ratings

Owner's of the Garmin GPS Receiver Garmin 18X GPS Receiver Module gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 38
 
190-00879-08 GPS 18x Technical Specifications Rev. D
Page 31
4. Select the serial port to which the GPS 18x
is connected. Select Auto to have the
program automatically determine the baud
rate, or select Manual to manually select
the baud rate of the GPS 18x. Click OK
when done.
5. Click the Connect icon
, or select
Comm > Connect to connect to the GPS
18x.
6. To view the current programming of the
GPS 18x, select Config > Get
Configuration from GPS (or press the F8
key). The current programming of the GPS
18x is displayed in the window, as shown
on the previous page.
7. Open the Sensor Configuration Window
by pressing the F6 key or selecting
Config > Sensor Configuration.
8. Place a check mark in the box next to
“Binary Output Data” to change the GPS
18x to Garmin Mode. The unit will keep
this change in the programming until you
change it again in the software.
Note: Selecting Config > Switch to
Garmin Mode (or pressing the F11 key)
only changes the unit to work in Garmin
Mode until power is cycled through the
unit again. For a more permanent
change, refer to step 8 above.
9. Click OK.
10. When you are ready to upload the
changes into the GPS 18x, select Config
> Send Configuration to GPS (or press
the F9 key). The new configuration is
then loaded into the GPS 18x.
11. You may disconnect and close the
software when finished. The software
configuration can also be saved for
future reference.
Refer to Appendix E: Sensor Configuration
Software
for complete information about downloading the Sensor Configuration Software application.

   Find Your Products By Category