3Com Switch 5500-EI User Manual

0

Out of 0 Ratings

Owner's of the 3Com Switch 5500-EI gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 152
 
Manually Configuring the IP Information 63
or <5500-xx> displays (where xx is either SI or EI) as shown in
Figure 27.
Once you have logged into the switch, you are automatically in User
View.
Figure 27 User View Login
3 Enter the system-view command and press Enter. The [5500-xx]
prompt displays (where xx is either SI or EI)
4 Enter interface vlan 1 and press Enter.
5 Enter the IP address and subnet mask for the switch as follows:
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
and press Enter.
(where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is
the switch’s subnet mask)
6 Enter the quit command to exit System View (and return to User View)
and then enter the switch’s default gateway using the following
command:
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the default gateway’s IP address)
7 From User View, enter the save command to save the configuration to
your switch (the configuration is not saved automatically when the switch
is powered down).
You can now set up your switch management method. See “Methods of
Managing a Switch” on page 56 to determine which method is best for
you. If you do not intend to use the command line interface through the
10014925-AD_S5500_GSG.book Page 63 Thursday, August 16, 2007 12:29 PM

   Find Your Products By Category