Axis Communications Security Camera Axis Communications Security Camera User Manual

0

Out of 0 Ratings

Owner's of the Axis Communications Security Camera Axis Communications Security Camera gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 46
 
29
AXIS M3011 - System Options
Notes:
• For NAT traversal to work, this must be supported by the broadband router.
• The broadband router has many different names: “NAT router”, “Network router“, Internet Gateway”, “Broadband
sharing device” or “Home firewall” but the essential purpose of the device is the same.
Enable/Disable - when enabled, the network cameras attempt to configure port mapping in a NAT router on your network,
using UPnP™. Note that UPnP™ must be enabled in the camera (see System Options > Network > UPnP).
Use manually selected NAT router - select this option to manually select a NAT router and enter the IP address for the router
in the field provided.
If a router is not manually specified, the network cameras automatically search for NAT routers on your network. If more than
one router is found, the default router is selected.
Alternative HTTP port - select this option to manually define an external HTTP port. Enter the port number in the field
provided. If no port is entered here a port number is automatically selected when NAT traversal is enabled.
Notes:
• An alternative HTTP port can be used/be active even if NAT traversal is disabled. This is useful if your NAT router does
not support UPnP and you need to manually configure port forwarding in the NAT router.
• If you attempt to manually enter a port that is already in use, another available port is automatically selected.
• When the port is selected automatically it is displayed in this field. To change this enter a new port number and click
Save.
FTP - The FTP server running in the network cameras enables the upload of new firmware, and user applications. Check the
box to enable the service.
RTSP - The RTSP protocol allows a connecting client to start an H.264/MPEG-4 stream. Check the box to enable the server
and enter the RTSP port number to use. The default setting is 554. Note that MPEG-4 and H.264 video streams will not be
available if this service is not enabled.
SOCKS
SOCKS is a networking proxy protocol. The Axis network camera can be configured to use a SOCKS server to reach networks
on the other side of a firewall/proxy server. This functionality is useful if the network camera is located on a local network
behind a firewall, and notifications, uploads, alarms, and such need to be sent to a destination outside the local network (such
as the Internet). See the online help
for more information.
QoS (Quality of Service)
Quality of Service (QoS) guarantees a certain level of a specified resource to selected traffic on a network. Quality can be
defined as a maintained level of bandwidth, low latency, and no packet losses. The main benefits of a QoS-aware network can
be summarized as:
• The ability to prioritize traffic and thus allow critical flows to be served before flows with lesser priority.
• Greater reliability in the network, thanks to the control of the amount of bandwidth an application may use, and thus
control over bandwidth races between applications.
The QoS in Axis network video products marks the data packets for various types of network traffic originating from the
product. This makes it possible for network routers and switches to reserve a fixed amount of bandwidth for these types of
traffic. The network cameras mark the following types of traffic:
•video
•event/alarm
• management network traffic

   Find Your Products By Category