Axis Communications Home Security System Axis Communications Home Security System User Manual

0

Out of 0 Ratings

Owner's of the Axis Communications Home Security System Axis Communications Home Security System gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 60
 
AXIS P5544 PTZ Dome Network Camera
System Options
The following traps are available:
•Coldstart
•Warmstart
•Linkup
• Authentication failed
SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 39. To enable SNMP v3, check the b ox and provide the initial user
password.
Note
The initial passwo rd can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to Factory Default Settings, on page 49.
UPnP
TM
The Axis product includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can b e disabled under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings a re configured under System Options > Network > RTP.
The RTP port range defines the range of ports from which the video/audio ports are auto
matically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protoc
ol.
Bonjour can be disabled under System Op
tions > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.
Important
ToaccesstheSDcard,thetopcovermustberemoved. Afterremounting the alignment of the lens may differ slightly
and the PTZ mechanics should be recalibrated. Go to System Options > Maintenance and click Calibrate PTZ.Formore
infor
mation, see PTZ Calibration, on page 47.
The Axis product supports SD cards with the following file systems:
• ext4 — recommended due to its resi lie nce against data loss if the card is ejected or if there is abrupt power loss. To a ccess
data stored on the card from the Windows operating system, a third- party ext4 driver or application is required.
• vFAT — most SD cards are pre-formatted with vFAT when purchased.
45

   Find Your Products By Category