AT&T Cordless Telephone DECT 6.0 User Manual

4.1

Out of 15 Ratings

Owner's of the AT&T Cordless Telephone DECT 6.0 gave it a score of 4.1 out of 5. Here's how the scores stacked up:

  • Reliability

    4.0 out of 5

  • Durability

    4.36 out of 5

  • Maintenance

    4.13 out of 5

  • Performance

    4.13 out of 5

  • Ease of Use

    3.8 out of 5
of 31
 
5
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the
table below). If necessary, place the handset in the telephone base
or charger to charge the battery. For best performance, keep the
handset in the telephone base or charger when not in use. The
battery is fully charged after 10 hours of continuous charging. See
Technical specifications on page 29 for battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 30 minutes to give the handset enough
charge to use the telephone for a short time. The screen shows
LOW BATTERY until you have charged the battery without interruption for at least 30
minutes. The following table summarizes the battery charge indicators and actions
to take.
Battery indicators Battery status Action
The screen is blank or shows
PLACE IN CHARGER.
Battery has no or very little
charge. The handset cannot
be used.
Charge without interruption (at
least 30 minutes).
The screen shows
LOW BATTERY
and flashes.
Battery has enough charge
to be used for a short time.
Charge without interruption (at
least 30 minutes).
The screen shows HANDSET X
and the battery icon shows
, or .
Battery is charged. To keep the battery charged,
place it in the telephone base or
charger when not in use.
notes:
If you are on a call in low battery mode, you hear four short beeps every 50 seconds.
If no battery is installed in the handset when you place it in the telephone base or charger, the
CHARGE light does not turn on and the screen shows NO BATTERY. Follow the instructions in
Battery installation on page 4 to install the battery.
•
•
10:30
PM
11/20
HANDSET 1
16 MISSED CALLS
Battery status icon
After you install your telephone or power returns following a power
outage, the handset will prompt you to set the date and time (see
page 9). To skip setting the date and time, press OFF/CANCEL.
SET DATE
--/--/--

   Find Your Products By Category