3M Computer Monitor MicroTouch User Manual

0

Out of 0 Ratings

Owner's of the 3M Computer Monitor MicroTouch gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 33
 
26 M150 FPD Monitor Installation Guide
You can use the Position option to center the image on the display manually. Use the
◄/left and ►/right arrow buttons to scroll through the position menu.
• H-Position is used to adjust the horizontal image position manually.
• V-Position is used to adjust the vertical image position manually.
Image
Use the ◄/left and ►/right arrow buttons to scroll through the image menu.
Phase: If the phase of your monitor is not fine-tuned, you may observe unstable
horizontal noise lines and cross-talk stretching from the edge of small windows on your
display.
If you change your display to Windows shut down mode, this noise will be more visible,
and easier to eliminate. Click on the "Start" button at the bottom right side, and then click
Shut Down. This will bring you to the Windows shutdown mode. After finishing phase
adjustment, click on the "Cancel” to return to your original Windows display.
Clock: If the clock setting of your image is not fine-tuned, you may observe periodic
vertical bars of video noise on your image. These bars of noise are usually adjusted out
when an Auto Configuration is performed. If the bars of noise are still present, this
setting can be adjusted manually.
Adjust this setting so that either the vertical bars of noise are replaced by an even amount
of noise across the whole screen, or the noise disappears completely.
If you do an Auto Config, the monitor will try to find the best Clock/Phase setting. If you
are not satisfied with the auto adjustment, fine-tune the phase manually as described
above.
3M Touch Systems Proprietary Information

   Find Your Products By Category