AT&T Headphones TL7600 User Manual

0

Out of 0 Ratings

Owner's of the AT&T Headphones TL7600 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 61
 
7
Getting started
Registering the headset
To register the headset to an AT&T DECT cordless telephone
base:
Make sure the battery is properly installed in
the headset (see page 3). The ON/OFF light
flashes twice every five seconds to indicate
the headset is not registered.
Place the headset in the headset charger
and allow it to charge for at least five
minutes before beginning registration. Leave
the headset in the charger while registering
the headset.
On the telephone base of the cordless
phone, press and hold the HANDSET
LOCATOR button until the IN USE light
comes on (about four seconds) and release
the button.
The headset registers to the telephone
base automatically; this may take about 30
seconds to complete. The IN USE light on
the telephone base turns off. The headset
ON/OFF light turns blue on the first headset
registered. The headset ON/OFF light turns
orange on the second headset registered. To
verify registration was successful, press the
headset ON/OFF button and check for a dial
tone.
NOTE: If the registration is not successful, the ON/OFF light on the headset
flashes twice every five seconds. Reset the headset and try again. Remove the
headset from the charger and press ON/OFF. Then place the headset back into
the headset charger. Try the registration process again.
1.
2.
3.
4.

   Find Your Products By Category