Uniden Marine Radio Marine Radio User Manual

5.0

Out of 1 Ratings

Owner's of the Uniden Marine Radio Marine Radio gave it a score of 5.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 52
 
27
English
channel switching. If you receive an individual call, the radio will respond with an
unattended code, just as if the radio were in Standby.
1. Press and hold
CALL-MENU
to display the normal menu.
2. Select Setup and then Auto CH SW.
3. Choose Off and press
ENT-1W/25W
. The radio will not automatically switch channels until
you reactivate this feature.
#NOTE: Use this feature with caution. Deactivating automatic switching and then forgetting it
can make it hard for you to receive DSC calls.
If you have unread incoming DSC calls, the radio displays a message icon. You will be able
to review who has called. The radio displays the last 10 distress calls and the last 20 non-
distress calls it received (see the receive log on page 28).
INSTALLING THE HARDWARE

Your radio can sit at any angle in the mounting bracket so it can easily accommodate the best
location. First, determine the best place to mount the radio. For optimum performance, find a
location that can:
x Properly support the weight of the radio, approximately 2.2 pounds or 1.0 kilograms.
You may need to use some type of anchor with the mounting screws to hold the radio,
depending on the surface.
x Keep the battery leads as short as possible.
x Keep the antenna lead-in wire as short as possible.
x Allow free air flow around the heat sink on the rear of the radio.
x Avoid interference with the ship’s compass.
1. Install the radio into the mounting bracket.
2. Position the radio into
the desired location.
Mark the edges of the
bracket on the mounting
surface.
3. Remove the mounting
bracket drill template
from the back of the
manual, and use the
template to mark
the drill holes on the
mounting surface.
4. Drill the holes for the
mounting bracket;
be sure to follow any
special requirements of the mounting surface.
1
2
Step 1:
Slide the radio
into the mounting
bracket.
Step 2:
Tighten the mounting knobs
to secure the radio in place.

   Find Your Products By Category