Canon Camcorder ZR200 User Manual

3.6

Out of 15 Ratings

Owner's of the Canon Camcorder ZR200 gave it a score of 3.6 out of 5. Here's how the scores stacked up:

  • Reliability

    3.71 out of 5

  • Durability

    3.71 out of 5

  • Maintenance

    3.43 out of 5

  • Performance

    3.79 out of 5

  • Ease of Use

    3.43 out of 5
of 152
 
128
List of Messages
Memory Card Related Messages
Message Explanation
SET THE TIME ZONE,
DATE AND TIME
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
22
CHANGE THE BATTERY
PACK
Battery pack is exhausted. Replace or charge the battery pack.
13
THE TAPE IS SET FOR
ERASURE PREVENTION
Cassette is protected. Replace the cassette or change the
position of the protect switch.
135
REMOVE THE
CASSETTE
Camcorder stopped operating to protect the tape. Unload and
reload the cassette.
16
CHECK THE INPUT DV cable or USB cable is not connected, or the connected digital
device is turned off.
82
CONDENSATION HAS
BEEN DETECTED
Condensation has been detected in the camcorder.
132
TAPE END Tape reached the end. Rewind the tape or replace the cassette. –
CHECK THE CASSETTE
[REC MODE]
You attempted to perform audio dubbing on a tape recorded in a
mode other than the SP mode.
84
CHECK THE CASSETTE
[AUDIO MODE]
You attempted to perform audio dubbing on a tape recorded in 16-
bit or 12-bit 4-channel sound.
84
CHECK THE CASSETTE
[BLANK]
You attempted to perform audio dubbing on a tape with a blank
section.
84
CHECK THE CASSETTE
[WRONG FORMAT]
You attempted to perform audio dubbing on a tape recorded in HD
format.
–
WRONG FORMAT
PLAYBACK NOT
POSSIBLE
You attempted to play back a tape recorded in HD format. –
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
You attempted to play back a copyright protected tape.
81
COPYRIGHT
PROTECTED DUBBING
RESTRICTED
You attempted to dub a copyright protected tape. May also appear
when an anomalous signal is received during analog line-in
recording, or during analog-digital conversion of a copyright
protected tape.
81
Message Explanation
NO CARD Memory card not is inserted into the camcorder.
88
THE CARD IS SET FOR
ERASURE PREVENTION
SD Memory Card is set for erasure prevention. Replace the card
or change the position of the protect switch.
88
NO IMAGES No images are recorded on the memory card. –
CARD ERROR A memory card error occurred. The camcorder cannot record or
play back the image.
The error may be temporary. If the message disappears after 4
seconds and “ ” flashes red, turn the camcorder off, remove
the card and reinsert the card. If “ ” changes to green, you can
continue recording/playback.
–
CARD FULL No remaining capacity on the memory card. Replace with another
card or erase images.
–
NAMING ERROR File or folder number has reached the maximum value.
91

   Find Your Products By Category