Black & Decker Blower Black & Decker Blower User Manual

0

Out of 0 Ratings

Owner's of the Black & Decker Blower Black & Decker Blower gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 28
 
MAINTENANCE
• CLEANING AND STORAGE
TURN OFF AND UNPLUG TOOL! (Unplug extension cord at power source.)
Use only mild soap and a damp cloth to clean the tool. Never let
any liquid get inside the tool; never immerse any part of the tool
into a liquid. Clean out any clippings which may have accumulated
in the Blower/Vac. When used properly with dry leaves the fan
chamber of your Blower/Vac should remain clean. If damp earth
and debris are ingested some of the particles may build up on the
inside of the fan chamber. If this happens the performance of the
unit will decrease. This area can be cleaned out using a wooden
stick as shown in figure 13 after disconnecting from the power
source. Your Blower/Vac should be stored in a dry place.
WARNING: SHOCK HAZARD. DO NOT POUR OR SPRAY
WATER ON THE TOOL IN AN ATTEMPT TO CLEAN.
Do not store the tool on or adjacent to fertilizers or chemicals.
Such storage can cause rapid corrosion of the metal parts.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unit will not start. • Fan cover or vac tube not installed. • Install fan cover for blow
mode or vac tube for vac
mode.
• Cord not plugged in. • Plug tool into a working
outlet.
• Circuit fuse is blown. • Replace circuit fuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue
use immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Circuit breaker is tripped. • Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip,discontinue use
immediately and
have it serviced at a Black
& Decker service center or
authorized servicer.)
• Cord or switch is damaged. • Have cord or switch
replaced at Black & Decker
Service Center or
Authorized Servicer.
• Unit jammed or clogged. • Debris blocking inlet/outlet or fan. • Unplug power cord.
Remove vac tube. Refer to
“Cleaning and Storage
Section - Maintenance”.
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center
nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
ACCESSORIES
Recommended accessories for use with your tiller are available from your local dealer or authorized service center. If
you need assistance regarding accessories, please call: 1-800-544-6986
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
8
13

   Find Your Products By Category