Axis Communications Security Camera Axis Communications Security Camera User Manual

0

Out of 0 Ratings

Owner's of the Axis Communications Security Camera Axis Communications Security Camera gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 114
 
Page 12 AXIS P13 Network Camera Series Installation Guide
6. Finally, turn the lens slowly clockwise until the status indicator flashes green (not red or
amber).
7. To exit the Focus Assistant, press the Control button again.
Note: The Focus Assistant is switched off automatically after 15 minutes.
8. Retighten the focus puller.
9. Open the Live View page in the web browser and check the quality of the image.
Notes:
• The view in front of the camera should not be changed during focus adjustment (steps 5 and 6). If the
camera is moved, or if a finger or other object is placed in front of the lens, steps 3 - 7 will have to be
repeated.
• If movements in front of the camera cannot be avoided, the Focus Assistant should not be used.
• If the Control button is not released within two seconds, AXIS Dynamic DNS Service is enabled instead
of the Focus Assistant.
• If the camera is mounted so that the Control button cannot be accessed, you can still use the Focus
Assistant. Follow the instructions above but mount the camera after step 4 (pressing the Control
button) instead and skip step 7.
Adjusting the back focus (AXIS P1311)
The back focus of AXIS P1311 might need to be
adjusted when attaching a new lens that has
specifications that are different from the original lens.
Turn the back focus screw clockwise to move the sensor
away from the lens by 0.5 mm/r. Do not force the screw
beyond the end stop since it can damage the camera.
Adjust zoom and focus (AXIS P1343/P1344/P1346/P1347)
To adjust the zoom and focus follow these instructions:
1. Open the product’s home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive, the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom and focus pullers on the lens by turning them anti-clockwise. Move the pullers
to set zoom and focus and check the quality of the image in the image window.
Note: If the camera is mounted so that one cannot look at the image and move the pullers at the same
time, use the Focus Assistant instead. See page 13.
5. Retighten the zoom and focus pullers.
Back focus screw

   Find Your Products By Category