AT&T Headphones TL7600 User Manual

0

Out of 0 Ratings

Owner's of the AT&T Headphones TL7600 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 61
 
6
Getting started
Registering the headset
To register a headset to the DECT headset base:
Make sure the battery is properly installed in
the headset (see page 3). The ON/OFF light
flashes twice every five seconds to indicate the
headset is not registered.
Place the headset in the headset charger and
allow it to charge for at least five minutes
before beginning registration. Leave the
headset in the charger while registering the
headset.
On the headset base, press and hold the PAIR
button until the MUTE light on the headset
base turns on (about four seconds) and release
the button.
Registration may take about 30 seconds to
complete. The MUTE light on the headset base
turns off. The headset ON/OFF light turns blue
on the first headset registered. The headset
ON/OFF light turns orange on the second
headset registered.
To verify registration was successful, press the
headset ON/OFF button and check for a dial tone.
If the registration is not successful, the
ON/OFF light on the headset flashes twice every
five seconds. To reset the headset, remove the
headset from the headset charger and try the
registration process again.
1.
2.
3.

   Find Your Products By Category