4.6

Out of 20 Ratings

Owner's of the AT&T Cordless Telephone DECT gave it a score of 4.6 out of 5. Here's how the scores stacked up:
  • Reliability

    4.65 out of 5
  • Durability

    4.55 out of 5
  • Maintenance

    4.47 out of 5
  • Performance

    4.6 out of 5
  • Ease of Use

    4.65 out of 5
of 10
 
5
Battery installation & charging
Install the battery as shown on the next page. Once you have installed the
battery, the screen indicates the battery status (see table below). If necessary,
place the handset in the telephone base to charge the battery. For best
performance, keep the handset in the charger when not in use. The battery is
fully charged after 16 hours of continuous charging. See the table on page 53
of the user’s manual for battery operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The screen shows LOW BATTERY and the backlight is off until
you have charged the battery without interruption for at least one hour. The
following table summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank. Battery has no charge and
the handset cannot be
used.
Charge without interruption until the
screen shows LOW BATTERY (at least
10 minutes).
The screen shows
PLACE IN CHARGER
and flashes.
Battery has very little
charge and the handset
cannot be used.
Charge without interruption until the
screen shows LOW BATTERY (at least
four minutes).
The screen shows LOW
BATTERY, flashes, and
the handset beeps.
Battery has enough charge
to be used for a short time.
Charge without interruption until the
screen shows HANDSET X (at least one
hour).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged, place it
in the telephone base or charger when
not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every
minute.