0

Out of 0 Ratings

Owner's of the Atdec TV Mount Atdec Back To Back Ceiling Mount gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 2
 
E Adjusting the viewing position of your display
M8 Small
Washer
M8 x 45mm
Screw
Hex Tool
Tighten
Loosen
(1) Loosen both M8x45mm screws on
one of the display brackets, and adjust
the tilt angle of the display to the
required position. Tighten the two lock-
ing screws with Hex Tool provided.
(2) Repeat for 2nd Display
WARNING: Do not attempt to
adjust tilt angle without firstly
loosening locking screws. Doing
so may damage the product.
-5° to 5°
3. Horizontal Adjust
2
1
3
Horizontal Bar
(1) To adjust the pan position of the display, loosen all four
M8 x 30mm screws with the 6mm Allen Key, then rotate the Hanger
Pole Collar to the desired position. Once in position, tighten all four
M8 x 30mm screws as tight as possible to lock the display in position.
Tighten
360° Rotation
6mm Allen Key
2. Pan Adjust
-5° to 25° Tilt
-5° to 25° Tilt
Follow steps K and L in the Telehook TH-3070-CTW Installation Instructions to attach adhesive vinyl and apply
ad
ditional secu
rity
1. Tilt Adjust
TFT Manufacturers are constantly releasing new monitor models, Atdec does not accept responsibility if the mounting hole pattern does not comply with
the international VESA standards. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice.
Published: 12.12.08 ©
F Refer to the Telehook TH-3070-CTW Installation Instructions
(1) Adjust grub screw 1 until the display sits
level. Once the display is level, tighten grub
screw
2 until it firmly tightens onto the
horizontal bar. Tighten grub screw
3 until it
firmly tightens onto the horizontal bar and
prevents it from moving.
(2) Repeat for 2nd Display Bracket
if required.