0

Out of 0 Ratings

Owner's of the APC Home Security System NETBOTZ gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 24
 
12
NetBotz Room Sensor Pod 155 Installation Manual
Connect Sensors
Only connect sensors supported by the appliance to which the NetBotz 155 is
connected. See the installation and quick configuration manual included with
your appliance.
Connect APC and third-party sensors to the four ports labeled Sensors on the
NetBotz 155.
• Third-party dry contact sensors require the NetBotz Dry Contact Cable
(NBES0304). To connect a sensor to the cable, follow the instructions
provided with the sensor and the instructions provided with the cable.
• Standard third-party 0-5 V sensors require the NetBotz 0-5 V Sensor
Cable (NBES0305). To connect a sensor to the cable, follow the
instructions provided with the sensor and the instructions provided with
the cable.
• If a sensor cable is not long enough, use an RJ-45 coupling (provided
with some sensors) and standard CAT-5 cabling to extend the cable up to
15 m (50 ft) for a Temperature/Humidity Sensor (AP9335TH) or a
Temperature Sensor (AP9335T) and up to 30.5 m (100 ft) for all other
supported sensors.
Configure and Monitor Sensors
Once your system is installed and receiving power, configure sensors and begin
monitoring your system using the software interface for the appliance.
See your appliance installation and quick configuration manual for
system installation details and for instructions on accessing the
software interface of the appliance.