0

Out of 0 Ratings

Owner's of the Cisco Systems TV Converter Box Cisco Systems TV Converter Box gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 20
 
10
Gigabit Interface Converter Installation Note
78-5399-03 Rev. A0
Removing a GBIC
Installing a GBIC with a Handle
To install a GBIC that has a handle, follow these steps:
Step 1 Remove the GBIC from its protective packaging.
Step 2 Check the label on the GBIC to verify that the GBIC is the correct model (SX, LX/LH, or ZX) for your
network.
Step 3 Remove the plug from the optical bore.
Step 4 Slide the GBIC into the module socket. See Figure 3. You can install the GBIC with the handle either
up or down.
a. If the handle is up during insertion, you must lower the handle after insertion to lock the GBIC in
place.
b. If the handle is down during insertion, you will hear a click that indicates that the GBIC is locked
in place.
Step 5 Verify that the GBIC handle is in the down position.
Figure 3 Installing a GBIC (With Handle)
Removing a GBIC
Two physical GBIC models are available. One GBIC model has a locking handle to secure the GBIC in
the module; the other model uses two clips, one on each side of the GBIC. This section contains
procedures for removing both GBIC models.
LINK
Plug
Pull handle down
to lock GBIC
in slot
51179
GBIC