ADTRAN Telephone Total Access User Manual

0

Out of 0 Ratings

Owner's of the ADTRAN Telephone Total Access gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 264
 
Section 4 User Interface Guide Total Access 600 Series System Manual
160 © 2004 ADTRAN, Inc. 61200624L1-1B
7
Set DLCI to the DLCI number. This DLCI should match what is programmed in
the network Frame Relay switch.
8
Set mode to B
RIDGE
A
LL
. Using this menu you also have the option to route
only IP packets and bridge all other data packets (R
OUTE
IP/B
RIDGE
O
THER
) or
route all IP data packets on this PVC (R
OUTE
IP).
9
Left arrow back to the main menu to save the changes.
Layer 2 Protocol (PPP) Configuration – T1 Interface
Step Action
1
From the main menu, select L2 P
ROTOCOL
and press <E
NTER
>.
2
Use the arrow keys to select the P
ROTOCOL
field for the T1 interface. Press
<E
NTER
>. Select PPP from the list of available protocols.
3
Highlight the C
ONFIG
menu for the T1 interface and press <E
NTER
>.
4
Set mode to B
RIDGE
ALL. Using this menu you also have the option to route
only IP packets and bridge all other data packets (R
OUTE
IP/B
RIDGE
O
THER
) or
route all IP data packets on this connection (R
OUTE
IP).
5
Highlight A
UTHENTICATION
and press <E
NTER
> to change options related to how
the link is established. Default is T
X
M
ETHOD
= N
ONE
and RX M
ETHOD
= N
ONE
. If TX M
ETHOD
and RX M
ETHOD
are set to any option
other than N
ONE
, TX/RX U
SERNAME
and P
ASSWORD
options appear. The
Total Access 6XX supports various combinations of PAP, CHAP, and EAP for
PPP authentication. Refer to
L2 Protocol (TDM–T1–PPP) > Config >
Authentication on page 91
for more details.
6
Left arrow out of the A
UTHENTICATION
menus, highlight the PPP menu, and
press <E
NTER
>. Use the PPP menus to configure parameters associated with
the PPP link. Refer to
L2 Protocol (T1 TDM–T1–PPP) > Config on page 91
for
more details.
7
Left arrow back to the main menu to save the changes.
Layer 2 Protocol Configuration – Ethernet Interface
Step Action
1
From the main menu, select L2 P
ROTOCOL
and press <E
NTER
>.
2
Highlight the C
ONFIG
menu for the ETH (Ethernet) interface and press <E
NTER
>.
Layer 2 Protocol (FRE) Configuration – T1 Interface (Continued)

   Find Your Products By Category